Initializing Of This Unit - Yamaha RX-V365 Service Manual

* When the version of the firmware to be written is the same as the one existing in this unit, "Same Version", "Please..."
and "Turn off!!" are displayed repeatedly. (Upgrading is not necessary.)
If the display remains unchanged for longer than 10 seconds after starting the firmware CD play procedure,
perform the firmware CD play procedure again from the beginning.
If "FILE CORRUPTED" is displayed after "Address:XXXXXX", make sure that the firmware CD is not corrupted and
perform steps 1 to 7 of "Operation Procedures" again.
If "Upgrade Failed" is displayed, perform Steps 1 to 7 of "Operation Procedures" again.
8. Press the "STOP" key of the DVD/CD player.
9. Press the "EJECT" key of the DVD/CD player to open the disc tray.
10. Remove the firmware CD from the disc tray and close the disc tray.
11. Press the "STANDBY/ON" key of the DVD/CD player to turn off the power.
12. Press the "STANDBY/ON" key of this unit to turn off the power.
13. Start up the self-diagnostic function mode of this unit and select "14. ROM VER/SUM" menu.
Have the firmware version and checksum displayed by using sub-menu, and then check that they are the same as
written ones.
* When the displayed firmware version and checksum are different from written ones, perform the "Operation
Procedures" all over again.
14. Press the "STANDBY/ON" key of this unit to turn off the power.
● Initializing of this unit
* After updating the firmware, be sure to initialize this unit.
1. Start up the self-diagnostic function mode and select "13. FACTORY PRESET" menu.
2. Select the "PRESET RSRV" menu.
PRESET INHIBIT (Initialization inhibited)
3. Press the "STANDBY/ON" key of this unit to turn off the power.
RX-V365/HTR-6230
PRESET RESERVED (Initialization reserved)
21