Installation - Zanussi ZNC12X User Manual

16 zanussi

Installation

Remove any promotion label from the
door.
It is dangerous to alter the specifications
or attempt to modify this product in any
way.
Care must be taken to ensure that the
appliance does not stand on the electrical
supply cable.
Any electrical work required to install this
appliance should be carried out by a
qualified electrician or competent person.
INSTALLING THE APPLIANCE
1. Remove all packaging and check
carefully for any signs of damage.
2. This oven is designed to fit into a
360mm high cupboard as standard.
When fitting into a 350mm high
cupboard:- Unscrew and remove the
4 feet from the bottom of the oven.
There are 3 tall feet and 1 short foot.
Replace the 3 tall feet with those
provided in the accessory pack. Do
not replace the short foot.
3. If fitting the microwave oven above a
conventional oven (position A) then
use the mylar sheet provided.
a. Cut the Mylar sheet to fit the
internal width of the unit.
b. Peel back the protective cover on
the tape and fix to the rear of the shelf
so that it covers the service gap.
Mylar sheet
Conventional
oven
4. Fit the appliance into the kitchen
cupboard slowly, and without force,
until the front frame of the oven seals
against the front opening of the
cupboard.
5. Ensure the appliance is stable and
not leaning. Ensure that a 5mm gap is
kept between the cupboard door
above and the top of the frame
5 mm