Table of Contents
Advertisement
2.1.3 Fast-freezing Function
By pressing T8 button the fast-freezing function activates and it powers the compressor continuously for 54
hours. To deactivate the function earlier than 54 hours, just press T8 button again.
The L4 led lights till the freezing function is activated.
2.1.4 Temperature Alarm
The alarm is activated when the temperature reaches –8°C: L5 led and the display flash and the buzzer sounds.
You can switch off the alarm by pressing the T9 button, and when the buzzer has stopped, the display shows the
max. reached temperature for 5 seconds and L5 led continues to flash. Only when the temperature goes below –
8°C also the L5 led will turn off.
If the alarm condition stops automatically without pressing T9 button, the buzzer stops to sound but L5 led and
the display will flash. By pressing T9, L5 led stops to flash, while the display will show the max. reached
temperature for 5 seconds.
2.1.5 Regulation of the Refrigerator Temperature
To change the set temperature in the refrigerator you need to press T2 button (increase) or T3 (decrease). It is
possible to set temperature from +2°C till +8°C.
Once you have pressed T2 or T3 button, the display will flash for 5 seconds showing the set temperature. The
display then will indicate a steady temperature which has been detected inside the freezer.
2.1.6 Refrigerator Holiday Function (only in cooler and bicompressor)
The max. temperature you can set in the refrigerator compartment reaches +8°C; by pressing T2 button once
again after having reached +8°C the symbol "H" on the display will indicate that the holiday function is activated.
With this function the refrigerator temperature is maintained at +15°C.
This temperature doesn't allow to conserve food, but it's very useful when you don't use the refrigerator
compartment as it avoids the formation of unpleasant smells.
To deactivate the function you need to set another temperature so that the "H" symbol disappears from the
display.
2.1.7 Refrigerator Control
The compressor is activated when both the evaporator and air sensor detect the cut-in temperature and is
turned off when the temperature detected by the air sensor reaches the cut-out temperature.
With low room temperatures the rest time of the compressor can be extremely long, therefore the control sytem
sets a max. deactivation time of 6 hours.
With high room temperatures the compressor can activate after a long time or even work continuously if the
thermostatic regulation is not adapt; therefore the control system sets a max. activation time of 18 hours.
Only for four star compartment: by low room temperatures a balance heater is activated automatically through an
electronic board provided with a sensor.
2.1.8 Fast-freezing Function in the Refrigerator (COOLMATIC)
The fast-freezing function activates by pressing T4 button and the refrigerator temperature is set automatically at
+2°C. The function deactivates automatically after 6 hours or by pressing T4 button.
The yellow L2 led lights as to indicate that the function is activated.
9/16
Hide quick links:
Advertisement
Table of Contents
