JVC KS-FX945R Service Manual page 19

3.2.22 Removing the main motor assembly / sub motor assembly
(See Fig.38 to 40)
(1) Remove the belt at the bottom.
(2) Remove the polywasher and pull out the mode gear.
(3) Pull out the reduction gear (B).
(4) Remove the polywasher and pull out the reduction gear
(A).
(5) Remove the two screws attaching the main motor assem-
bly.
(6) Remove the two screws E attaching the sub motor assem-
bly.
(7) Unsolder the wires on the reel board if necessary.
CAUTION:
When reassembling, adjust the length of the wires ex-
tending from the sub motor asswmbly by attaching them
to the side of the sub motor assembly with the wires ex-
tending from the main motor assembly using a spacer.
Reduction gear (B)
Belt
Polywasher
Fig.38
Reduction gear (B)
E
Spacer
Sub motor assembly
Fig.39
Main motor assembly
Sub motor assembly
Fig.40
D
Main motor
assembly
Reduction
gear (A)
Polywasher
Sub motor
assembly
E
Mode gear
Polywasher
Reduction gear (A)
D
Main motor assembly
Spacer
(No.49875)1-19