JVC KS-FX945R Service Manual page 106

• When using the optional stay
• При использовании дополнительной стойки
Washer
Dashboard
Less than 30˚
Removing the unit
• Before removing the unit, release the rear section.
1
Remove the control panel.
2
Remove the trim plate.
3
Insert the 2 handles into the slots, as shown. Then, while gently pulling the handles away from each
other, slide out the unit. (Be sure to keep the handles after installing it.)
1
Control panel
Parts list for installation and connection
The following parts are provided with this unit.
After checking them, please set them correctly.
Hard case/Control panel
Power cord
Mounting bolt (M5 x 20 mm)
Stay (option)
Fire wall
Lock nut
Screw (option)
Sleeve
Mounting bolt
Install the unit at an angle of less than
30˚.
2
Trim plate
Handles
Rubber cushion
• When installing the unit without using the sleeve
• При установке устройства без использования муфты
In a Toyota for example, first remove the car radio and install the unit in its place.
Flat type screws (M5 x 6 mm)*
Bracket*
Pocket
Note : When installing the unit on the mounting bracket, make sure to use the 6 mm-long screws. If longer
screws are used, they could damage the unit.
Примечание :
Удаление устройства
1
2
3
Список деталей для установки и подключения
Sleeve
Washer (ø5)
Battery
2
Bracket*
(После установки сохраните рычаги.)
3
Handle
Trim plate
Lock nut (M5)
Remote controller
CR2025
* Not included with this unit.
Flat type screws (M5 x 6 mm)*