Using Your Recorder - Insignia NS-DRVCR User Manual

Connecting a digital camcorder
DV digital camcorder
• Use a DV cable (not supplied) to connect the
DV in/out jack of your DV digital camcorder to
the front panel DV IN jack of your recorder.
Note This jack is for connection to DV equipment
only. It is not compatible with digital satellite
tuners or D-VHS video decks.
Remote control batteries
The remote control requires two AAA (RO3)
batteries (not included). We recommend that you
replace the batteries on a yearly basis or when
the operation of the remote control becomes
intermittent or unsatisfactory. Replace the
original batteries with new AAA batteries. Do not
mix old and new batteries or different types of
batteries.
To replace the batteries:
1 Press the lock tab of the battery holder and
open the battery compartment.
2 Place two AAA batteries in the battery holder,
matching the + and – in the battery
compartment.
12
Front of recorder
Setting your recorder's RF output channel

Using your recorder

Turning your recorder on and off
Initial Setup Wizard
www.insignia-products.com
NS-DRVCR DVD Recorder/VCR
3 Close the battery holder.
Caution • Use only the size and type of batteries
specified.
• Make sure that you follow the correct
polarity as indicated in the battery
compartment. Reversed batteries may
damage the device.
• Do not mix different types of batteries
together (for example, Alkaline and
Carbon-Zinc) or old batteries with new
ones.
• If the remote is not to be used for a
long period of time, remove the
batteries to prevent damage or injury
from possible battery leakage.
• Do not try to recharge batteries not
intended to be recharged. They can
overheat and rupture.
If you use the RF cable connection to connect
the recorder to your TV, you must set the
recorder's RF channel output and tune your TV
to this channel to be able to see the Setup
Wizard and various menus used in setting up
your recorder.
To set the recorder's RF output channel:
1 When the recorder is turned off, press and
hold CH ( / ) on the front panel for more
than five seconds. [RF03] or [RF04] appears
in the display window.
2 Press CH ( /
channel (RF03 or RF04).
3 Tune the TV to this channel.
To turn your recorder on and off:
1 Plug the power cord into an electrical outlet.
2 Press the POWER button to turn on your
recorder.
3 Press the POWER button again to turn off
your recorder.
The first time you turn on the recorder, the Initial
Setup Wizard opens so you can set the
language, channels, and clock.
To set up your recorder with the Setup Wizard:
1 Use / to select a language for the Setup
menu and on-screen display, then press
ENTER.
2 Check your antenna connections, then press
.
3 Press ENTER to begin the channel search.
) to change the RF output