On / Off
Comfort Grip Handle
14000 OPM (Orbits per Minute)
120 Volts, 60 Hz AC
Non-Adhesive Sandpaper and Adhesive Sandpaper
when you are assembling parts, making adjustments, installing or removing
sandpaper, cleaning or when it is not in use. Disconnecting the sander will prevent
accidental starting, that could cause serious personal injury.
INSTALLING THE SANDPAPER (See Figs. 3, 3a, 3b on page 14 and Fig. 4 on page 15)
This sander has a cushion that allows you to use either non-adhesive sandpaper or
pressure sensitive adhesive-backed sandpaper. The non-adhesive sandpaper clamps
to the front and back of the platen and cushion. Adhesive backed sandpaper is applied
directly onto the cushion.
This sander has a dust collection system that collects dust from the work surface through
holes located in the platen and cushion on the bottom of the sander. A paper punch
template is included for accurately punching holes into the 1/4-sheet sandpaper.
NOTE: Holes must be punched into the paper for the dust collection system to
work properly. See instructions on page 16 to punch holes.
Installing Non-Adhesive Sandpaper (See Figs. 3, 3a and 3b)
with dual dust ports
Your sander should NEVER be connected to the power source
Paper Clamp Lever