Bond user manual Instructions Manual page 9

Step 3
a) Align the holes on the right side of the body assembly with
the holes on the heat plate support
b) Insert the pre-installed bolts on the right handle
holes and seal them with one flat washer （ HH） , one spring
washer (GG),and one nut(II).
c) Repeat the procedure for the left handle
d) Align the hole on the ignition cable with the hole on the
bottom of the body assembly.
e) Insert one bolt (BB) into the hole and seal it with one flat
washer (DD) one spring washer (CC) and one nut (EE)
f) Go back and tighten all the bolts using the screwdriver
provided.
BB M5 × 10 Bolt
CC M5 Spring washer
DD Flat washer
EE M5 Nut
HH Flat washer
GG Spring washer
II M6 Nut
80102
Owner's Manual
.
J
L
K
.
1 PC
1 PC
1 PC
1 PC
4 PCS
4 PCS
4 PCS
O
into the
Step 4
a) Align the holes on the lower right front side and lower
right back side of the body assembly with the holes on
the right leg
b) Insert one bolt (BB) into each pre-drilled hole and seal it
with one flat washer (DD), one spring washer (CC) and
one nut (EE).
c) Repeat the procedure for the left leg
d) Go back and tighten all the bolts using the screwdriver
provided.
BB
DD
CC
EE
9
.
O
M5 × 10 Bolt 8 PCS
Flat washer 8 PCS
M5 Spring washer 8 PCS
M5 Nut 8 PCS
L
.
N