Excess Flow Safety Valve Reset Procedure; Care And Maintenance - Bond user manual Instructions Manual

WARNING: Always monitor the grill closely when cooking and turn the flame level down (LOW) or OFF if flare-
ups intensify.
Shutting off the burner:
Always turn the valve knob clockwise all the way to the "LOCK OFF'' position.
Promptly disconnect the propane cylinder.

Excess flow safety valve reset procedure

A sudden shut off of the gas flow typically occurs if you open the LP tank valve rapidly.
This procedure is effective with all LP tank sizes.
To ensure the procedure is performed safely and successfully, please carefully follow the instructions below.
1. Turn the regulator valve to the "LOCK OFF" position.
2. Disconnect the LP tank from the regulator valve.
3. Open the lid of the grill.
4. Turn regulator valve to HIGH.
5. Wait at least one minute.
6. Turn the regulator valve to the "LOCK OFF" position.
7. Wait for at least five minutes.
8. Re-connect the LP tank to the regulator valve.
9. With the lid open, turn the regulator valve to the high position and light the grill.
10. Observe stainless steel plate when lit: It should feel warm after five to ten seconds and the color of the stainless steel
plate should turn red in two to three minutes.
11. If the grill does not light, turn the regulator valve to the "LOCK OFF" position and disconnect the LP tank. Then contact
the customer service center for further assistance.

Care and Maintenance

IMPORTANT
Always allow to completely cool off before covering your grill to prevent corrosion from condensation.
Caution: All cleaning and maintenance should be done when the grill is cool, with the fuel supply turned off at the
control dial and the propane cylinder disconnected. DO NOT clean any grill part in a self-cleaning oven. The extreme
heat will damage the finish.
Cleaning the Burner Assembly
Burning off the grill after every use (approx. 15 minutes) will keep excessive food residue from building up.
Recommended cleaning materials -
Mild dishwashing liquid detergent
Nylon cleaning pad
Paper clip
Compressed air
DO NOT use cleaners that contain acid, mineral spirits or xylene.
Outside surfaces
Use a mild dishwashing detergent and hot water solution to clean. Rinse thoroughly with water.
Inside surfaces
If the inside surface of the grill lid has the appearance of peeling paint, baked-on grease has turned to carbon and is
flaking off. Clean thoroughly with a strong solution of detergent and hot water. Rinse with water and allow it to
completely dry.
Interior of grill bottom – Remove residue using brush, scraper and/or cleaning pad. Wash with a dishwashing
detergent and hot water solution. Rinse with water and let dry.
Cooking Grids – The stainless steel plate grates have a glass-like composition that should be handled with care.
Use a mild dishwashing detergent or baking soda and hot water solution. Non-abrasive scouring powder can be
used on stubborn stains. Rinse with water.
Heat Plates – Clean residue with wire brush and wash with soapy water. Rinse with water.
80102
Owner's Manual
Hot water
Heat Resistant Acrylic brush
Putty knife/scraper
14