Assembly Instructions - Bond user manual Instructions Manual

Remove all contents from the carton packaging. Make sure all parts are present before attempting assembly. Once the grill
is fully assembled, go back and check to make certain all the bolts are secure. Tighten again using the screwdriver
provided if necessary.
Estimated Assembly Time: 20 minutes.
Step 1
a) Align the holes on the right back side of body assembly
with the holes on the lower hinge
M
b) Insert one bolt (BB) into the pre-drilled hole, sealing it
with one flat washer (DD
one nut (EE)
c) Repeat the procedure for the left back side of body
assembly.
d) Go back and tighten all the bolts using the screwdriver
provided.
BB M5 × 10 Bolt
DD
Flat washer
CC M5 Spring washer
EE M5 Nut
I
80102
Owner's Manual

Assembly Instructions

.
)
one spring washer (CC) and
4 PCS
4 PCS
4 PCS
4 PCS
M
Step 2
a) Insert the venturi side of the burner
the hole on the right side of body.
b) Put the heat shield between the burner and the body
c) Align the pre-drilled hole under the burner
the hole on the heat shield
the bottom of body
d) Insert one flat washer (HH
(GG) and one bolt (FF) into the pre-drilled hole.
e) Tighten the bolt using the screwdriver provided.
f ) Screw the regulator valve
venturi tube of the burner.
HH
GG
FF
8
and the hole on
I
.
M
)
, one spring washer
into the threaded
Flat washer 1 PC
Spring washer 1 PC
M6 × 7 Bolt 1 PC
through
with