Bond user manual Instructions Manual page 10

Step 5
a) Place the heat plate
b) Place the cooking grid
certain the cooking grid is clipped by the fastener.
Step 7
a) Insert the pre-attached bolts on the lid handle
holes on the front of the lid and seal with one flat washer
(HH), one spring washer (GG),and one nut (II).
b) Align the holes on the back side of lid with the holes on the
upper hinge .
c) Insert one bolt (BB) into each pre-drilled hole and seal with
one flat washer (DD), one spring washer (CC) and one nut
(EE)
d) Go back and tighten all the bolts using the screwdriver
provided.
BB M5 × 10 Bolt
DD Flat washer
CC M5 Spring washer
EE M5 Nut
HH Flat washer
GG Spring washer
II M6 Nut
80102
Owner's Manual
on the heat plate support.
upon the heat plate and make
into the
2 PCS
2 PCS
2 PCS
2 PCS
2 PCS
2 PCS
2 PCS
Step 6
a) Insert the grease cup
underneath the grill and push forward until it is in
place.
10
P
into the two guides