Audio Settings; Bypass Master Volume; Resampling Frequency - Bladelius EMBLA User Manual

Bladelius Embla
Reference - Audio Settings

Audio Settings

Bypass master volume

You can bypass the preamplifier/volume section in Embla by setting this to on
(bypass).
Caution: if you set it to "On" the level will be very high if connected to an
amplifier.
Use this setting when Embla is used together with a preamplifier or integrated
amplifier.
Options
Off *) Bypass volume control is disabled. Volume control is enabled.
On Bypass volume control is enabled. Volume control is disabled.
Note! This setting cannot be changed when playing or when an external
source is selected. The system has to be in stop mode.

Resampling frequency

By resampling to a higher sampling frequency you move out of noise further
away from the audio band.
Options
44 kHz Resampling frequency is 44.1 kHz.
48 kHz Resampling frequency is 48 kHz.
96 kHz Resampling frequency is 96 kHz.
192 kHz *) Resampling frequency is 192 kHz.
Opt Default with Filter C. Optimized for analog like sound.
© 2009 by Bladelius Design Group. All rights reserved
User Manual
15