Kenmore 233.5992 Series Use & Care / Installation Manual page 8

1. Place range hood body on its back, with controls
facing up. Place cardboard under hood to protect
countertop or table finish.
2. Position the curved plate glass over the range hood
body as shown.
3. Install rubber bushings into all (4) holes of the glass.
4. Place a plastic decorative washer onto (4) M4 x
1-in. flathead mounting screw.
5. Align holes in glass with holes in the range hood
body. Install and fasten (4) black, flat-head screws
with decorative washers through rubber bushings
and into the range hood body.
6. Hand-tighten screws, but do not overtighten.
1. Remove the grease filter by pushing in the metal
latch tab. Pull filter out to remove.
2. Install (2) Type B10, 40-Watt maximum, incandes-
cent candelabra bulbs (included).
Note: When replacing bulbs, remove the non-ducted
filter (if installed) to ease lamp installation.
1. Install damper/duct connector to top of hood using
(4) #8 x 3/8" pan head mounting screws.
Note: Damper flaps must be removed and discarded
for non-ducted installations.
INSTALL CURVED GLASS PLATE
INSTALL BULBS
INSTALL DUCT CONNECTOR
8
(4)
M4 X 1-IN.
SCREWS
(BLACK)
(4)
BUSHINGS
NON-DUCT
FILTER
GREASE
FILTER
DAMPER
FLAPS
(4)
#8 X 3/8"
PAN HEAD
SCREWS
DAMPER/DUCT CONNECTOR