Kenmore 233.5992 Series Use & Care / Installation Manual page 11

INSTALL THE HOOD (NON-DUCTED HOODS ONLY)
Note: Purchase Non-Duct
Kenmore part number 59921.
1. CAUTION: Use only expandable
aluminum duct provided with non-duct
kit.
2. Do not remove the protective plastic
film covering the decorative flue at this
time.
3. Remove damper
damper/duct connector
discard flaps.
NON-DUCT PLENUM
NON-DUCT COLLAR
6" ALUMINUM
FLEX DUCT
DAMPER / DUCT
CONNECTOR
4. Attach non-duct collar to non-duct
plenum using (4) #8 x 3/8" pan
head screws.
5. Measure distance "A". Cut a length
of flexible metal duct (extended) to
this dimension.
6. Attach aluminum flexible duct to
the damper / duct connector with
a tie wrap.
7. Attach flexible duct to non-duct
plenum collar and secure with tie
wrap. Tape all joints with duct tape.
8. Remove protective plastic film
covering the lower flue only.
9. Carefully place both flues into the
recessed area of hood top.
10. Attach non-duct plenum with collar
to upper flue using (4) #8 x 3/8"
pan head screws.
11. Hold hood up close to wall mounting
location and plug power cord into
wall outlet.
12. Align the hood and center it above
the hood mounting bracket. Gently
lower the hood until it securely
engages the bracket.
Kit,
13. If a framing
member is
not present:
With the
hood hanging
in place, drill
through both
holes located
in the inside
flaps from
lower back
and
of hood using
a 5 ⁄16" drill
bit. Insert
the included
drywall
4-7/8"
anchors into
the drilled holes (one for each hole).
14. Install (2) washers and (2) #8 x 1-1/2" mounting screws
A
through the back of the hood and into the drywall
anchors. Verify that the hood is centered and leveled.
Tighten all screws completely.
15. Slide up the upper flue
until it is aligned with its
mounting bracket. The
bracket should be inside the
flue. Secure the upper flue
on the upper flue mounting
bracket using (2) #8 x 3/8"
mounting screws.
16. Remove protective plastic
film covering the flue and
the hood.
NON-DUCT
MOUNTING
RECIRCULATION
17. Install the non-duct recirculation filter as shown. Turn
18. Reinstall grease filter by aligning rear filter tabs with slots
SIDE VIEW
FILTER
TABS
NON-DUCT
FILTER
mounting tabs on hood to secure filter.
in the hood. Push in the metal latch tab, push filter into
position and release. Make sure filter is securely engaged
after installation.
11
INSIDE
BACK
OF
HOOD
ASSEMBLY
Ø5/16"
HOLE LOCATIONS
UPPER FLUE MOUNTING
BRACKET - FRONT VIEW
UPPER
FLUE
METAL
LATCH
GREASE FILTER
MOTOR/
BLOWER
TYP.