Insignia IS-CM100751 User Manual page 6

IS-CM100751_combined.fm Page 4 Tuesday, April 12, 2005 10:14 AM
4 Insert the hooks into the guide holes.
5 Slide the tilt/swivel stand toward the front of the monitor until the latch
snaps into place.
6 Turn the monitor and the stand upright.
To remove the tilt/swivel stand:
1 Make sure that the power is turned off to the monitor.
2 Set the monitor face down with the underside facing you. Be careful not
to scratch the monitor screen.
3 Press the latch, then pull the tilt/swivel stand toward the back of the
monitor.
4 Pull the stand away from the monitor.
To connect the video cable and power cord:
1 Turn off your computer and monitor.
2 Connect the VGA cable to your computer's VGA port.
3 Tighten the VGA connector's thumbscrews to secure it to your computer.
4 Plug the power cord into the AC receptacle located on the back of your
monitor.
5 Plug the other end of the power cord into an AC outlet.
4
www.Insignia-Products.com
IS-CM100751 19-inch Color Monitor
VGA cable
Power cord