JVC UX-H35 Service Manual page 16

3.2.2 Removing the head amplifier & mechanism control board
(See Fig.4)
(1) Turn over the cassette mechanism assembly and remove
the three screws A attaching the head amplifier & mecha-
nism control board.
(2) Disconnect the flexible wire from connector
head amplifier & mechanism control board.
(3) Disconnect connector
anism control board from connector
board.
REFERENCE:
If necessary, unsolder the 4-pin wire soldered to the main mo-
tor.
3.2.3 Removing the main motor
(See Fig.4~7)
(1) Remove the two screws B.
(2) Half raise the motor and remove the capstan belt from the
motor pulley.
ATTENTION:
Be careful to keep the capstan belt from grease. When reas-
sembling, refer to Fig.6 and 7 for attaching the capstan belt.
Main motor assembly
Capstan belt
1-16 (No.MB053)
CN31
CN32 of the head amplifier & mech-
CN1 on the reel pulse
Fig.5
Head amplifier & mecha control board
on the
CN31
Flexible wire
Capstan belt
Capstan belt
A A
CN32
4pin wire
B
A
Main motor assembly
Fig.4
Main motor assembly
Motor pulley
Fig.6
Main motor assembly
Fly wheel
Motor pulley
Fig.7