Setting The Time Code - Panasonic AG-AC90AP Operating Instructions Manual

Setting the Time Code

Time code will display the recording time in hours, minutes, seconds, and frames.
TC 00:00:00:00 (hour : minute : second : frame [NDF])
TC 00:00:00.00 (hour : minute : second . frame [DF])
≥ The frame (Number of frames counted every second) will vary depending on the [REC FORMAT]
setting. (l 94)
[PS 1080/60p], [PH 1080/60i], [PH 1080/30p], [HA 1080/60i],
[HE 1080/60i], [PM 720/60p], [SA 480/60i], [CS 480/60i]
[PH 1080/24p]
[TC MODE]
Select the compensation mode for the time code.
MENU
: [RECORD SETUP] # [TC MODE] # desired setting
[DF]:
[NDF]:
≥ It is automatically set to [NDF] when the [REC FORMAT] is set to [PH 1080/24p] or the Interval
Recording is used.
[TCG]
Sets the way the time code will move.
MENU
: [RECORD SETUP] # [TCG] # desired setting
*
[FREE RUN] :
[REC RUN]:
* An error may occur when the playback mode is switched when the [REC FORMAT] is set to [PH
1080/24p].
≥ It is automatically set to [FREE RUN] when it is set to PRE-REC.
≥ The time code will reset when the built-in lithium battery is exhausted when it is set to
[FREE RUN].
Recording format
Time code is compensated in accordance with the actual time. It is
mainly used for broadcasting such as TV programs.
It will not compensate the time code. (There will be a difference from
the actual time)
It will constantly move.
It will move only when recording.
- 52 -
Frame
0 to 29
0 to 23