D.T.Systems H20 1810 PLUS Owner's Manual page 10

H20 plus series electronic dog trainer
Table of Contents

Advertisement

PARTS & FUNCTIONS
Rise Button
(H
2
0
1830
PLUS only)
Pressing the button on the right (#2) of the transmitter
will make the collar give a stimulation that gradually
increases in intensity level the longer the 'Rise' button
is pressed.
Locate and Run/Point Buttons
(H
2
0
1850
PLUS only)
Pressing the 'Locate' button on the left side (#1) of the
Transmitter will make the Collar Receiver beep.
Pressing the 'Run/Point' button on the right side (#2)
of the Transmitter will activate the Run & Point mode
on the Collar Receiver. Pressing the button again will
change the mode to the Point Only mode. Pressing
the 'Locate' button will cancel the Run/Point modes.
Battery Charging Receptacles
The battery charging receptacles are located on the
side of the Transmitter and on the side of the Collar
Receiver facing the dog's neck. After charging,
always close the jack with the rubber plug to prevent
foreign particles from getting inside the unit.
NOTE
The unit is still waterproof even if water gets into the charg-
ing receptacle. However, if water should get in, we recom-
mend rinsing out the charging receptacle and allowing it to
dry, especially after use in salt water. This will prevent pre-
mature corrosion in the metal pins inside that make contact
with the charger plug.
10

Advertisement

Table of Contents
loading

This manual is also suitable for:

H20 1820 plusH20 1830 plusH20 1850 plus

Table of Contents