Connecting The Monitor - Fujitsu Siemens Computers MCM 153V Operating Manual

Connecting the monitor

See your PC's operating manual for details of the ports on the system unit.
Please note the safety information provided in the chapter
!
Operating Manual of the PC.
Do not cover the ventilation openings of the monitor.
If you are assembling monitors beside each other, there must be a minimum distance of
30 cm between monitors of the same constructional type, to avoid image distortion. With
different monitors, the distance must be increased, if necessary.
1 = Power connector


Be sure that the monitor and the system unit are switched off.
The system unit's power plug must be pulled out!
!
The data cable (2) is permanently attached to the monitor. It has a 15-pin D-SUB connector for the
screen controller of the system unit.
See your PC's operating manual for details of the ports on the system unit.


Connect the 15-pin connector of the data cable to the (active) monitor port on the system unit
and secure the plug-in connection by tightening the safety screws.
If your system unit has two monitor ports ("onboard" screen controller and separate
i
graphics card), the monitor port for the separate graphics card is usually active.


Plug the power cable supplied into the power connector of the monitor.


Plug the power cable into the monitor connector at the rear of the system unit.


Plug the power connector of the system unit into a properly grounded power outlet.
A26361-K563-Z100-2-5E19
1
2 = Data cable
Color monitor MCM 153V
"Important notes" in the
2
English - 9