StreamLight Vintage Operating Instructions Manual page 4

Mounting
1. Select the desired position above
or below the helmet brim.
2. Loosen the locking screw.
3. Slide the clamp assembly over the brim of
the helmet and rotate it to the desired position.
4. The wedge can be used to direct the beam upward
or downward. Place it on the portion of the helmet clamp
that is located opposite the locking screw.
5. Tighten the locking screw until the Vantage
A coin can be used to tighten the locking screw. (Do not use screwdriver.)
Switch Operation
®
The Vantage features a switch knob that turns in
either direction to activate the main and the tail LEDs.
Maintenance
Use a soft cloth and mild detergent to clean the LED
lenses and keep them free of dirt and grime.
NOTE: Always avoid aggressive cleaning solutions
as they may damage the Vantage
®
is securely attached to the helmet.
®
.
Locking
Screw
Helmet
Clamp
Wedge
Off
On On