To Check The Transmission Status; To Enjoy Sound By Using Headphones; When You Use Multiple S-Air Products; Step 3: Setting Up The Wireless System - Sony DAV-HDX589W Operating Instructions Manual

34
us
The surround amplifier turns
off or its protection is active.
Sound transmission is not
established.
The surround amplifier does
not output sound.
Sound transmission is
established.
When you use multiple S·AIR
products
See "Establishing sound transmission between
the unit and S-AIR sub unit (ID setting)"
(page 74).
mmI
• The volume of the unit may become minimum if you
turn off the surround amplifier while the headphones
are connected to the surround amplifier, or radio
reception is poor. In this case, "HP NO LINK" and
"VOLUME MIN" appear alternately in the front
panel display. Check radio reception, and set the
volume again.
For details of the surround amplifier, see
"Surround amplifier operation" (page 97).
Flashes green.
To enjoy sound by using
headphones
You can enjoy the system's sound by connecting
the headphones to the PHONES jack on the
surround amplifier.
Turns off.
Turns red.
POWER I ON LINE Status
indicator
Turns green.
To check the transmission status
You can check the status of sound transmission
between the unit and surround amplifier by
observing the POWER / ON LINE indicator of
the surround amplifier.
S-AIR 10 switch
SURROUND
SELECTOR switch
POWER
POWER / ON LINE
Indicator
PHONES jack
The unit transmits sound to the surround
amplifier that is connected to the surround
speakers. To establish sound transmission,
perform the following Steps.
1
Press
1/6
on the unit.
The system turns on.
2
Set the SURROUND SELECTOR switch
of the surround amplifier to
SURROUND.
3
Set the S-AIR 10 switch of the surround
amplifier to A.
4
Press POWER on the surround
amplifier.
The POWER / ON LINE indicator turns
green. If it doesn't, check the transmission
status as follows.
To use the wireless system, you need to set up
the surround amplifier. Before setting, make
sure that the wireless transceivers are inserted
into the unit and the surround amplifier correctly
(page 31).
This wireless system is called "S-AIR." For
details of the S-AIR function, see "Using an
S-AIR Product" (page 73).
1/6
~
Step 3: Setting up the
Wireless System