Setting The Type Of Video Output To Match Your Tv; To Quit The Quick Setup; To Recall The Quick Setup Display - Sony DAV-HDX589W Operating Instructions Manual

The Quick Setup display appears.
37
US
Depending on the connection of the TV
(page 26), select the type of video output of the
system.
To select the type of video signal
output from the HDMI OUT jack
When you connect the unit and the TV with an
HDMI cable, select the type of video signals
output from the HDMI OUT jack.
For details, refer also to the operating
instructions supplied with the TV/projector, etc.
1
Press FUNCTION +/- repeatedly until
"OVO" appears in the front panel
display.
2
Press 0 OISPLAY while the system is
in stop mode.
The Control Menu display appears on the
TV screen.
3
Press
.,./~
to select [SETUP],
then press
O.
The options for [SETUP] appear.
4
Press
.,./~
to select [CUSTOM], then
press
O.
The Setup Display appears.
5
Press
""~
to select [HOMI SETUP], then
press
O.
The options for [HDMI SETUP] appear.
6
Press
""~
to select [HOMI
RESOLUTION], then press
o.
7
Press
.,./~
to select the desired setting,
then press
o.
• [AUTO (1920 x 1080p)]: The system
outputs the optimal video signal for the
connected TV.
• [1920 x 1080i]: The system outputs 1920
x 1080i * video signals.
• [1280 x nOp]: The system outputs 1280 x
nop* video signals.
4
Press
.,./~
to select [QUICK], then press
O.
CUSTOM
CUsTOM
IQUICK
To quit the Quick Setup
Press 0 DISPLAY in any Step.
To recall the Quick Setup display
1
Press FUNCTION +/- repeatedly until
"OVO" appears in the front panel
display.
2
PreSSI 0 OISPLAY while the system is
in stOlp mode.
The Control Menu display appears on the
TV screen.
3
Press
""~
to select" [SETUP],
then press
O.
The options for [SETUP] appear.
em
• Loud test sounds are output when [AUTO
CALIBRATION] starts. You cannot tum the
volume down. Give consideration to children
and neighbors.
• Before [AUTO CALIBRATION], install the
surround amplifier in the appropriate location. If
you install the surround amplifier in an improper
location, such as another room, proper
measurement will not be obtained.
• The environment of the room in which the
system is installed may affect measurements.
When the measurements differ considerably
from the status of the speaker installation,
perfonn the speaker settings manually by
following "Settings for the speakers" (page 65).
11
Unplug the calibration mic, press
+-1-+
to select [YES], then press
e.
Quick Setup is finished. All connections
and setup operations are complete.
10
Press
+-1-+
to select [YES], then press
O·
[AUTO CALIBRAnON] starts.
Be quiet during the measurement.