Stove Operation; Lighting The Stove; Turning The Stove Off; Power Failure - Stanley Ashling Installation And Operation Instructions Manual

STOVE OPERATION

NOTE: THE STOVE MUST BE COMMISSIONED
BY AN AUTHORISED STANLEY SERVICE AGENT
PRIOR TO THE FIRST OPERATION.

Lighting The Stove

1. Turn the control knob to Setting 2 (See Fig.20),
press and hold the ignition switch. After
approximately 60 seconds, a flame should
should appear in the combustion chamber,
release the ignition switch when the flame
appears. Do not hold down the ignition switch
for any longer than 90 seconds.
NOTE: IF THE STOVE FAILS TO LIGHT, TURN
THE CONTROL KNOB TO 0 AND CONTACT
WATERFORD STANLEY CUSTOMER SERVICE
DEPARTMENT.
2. Allow the stove to stabilise for 15 minutes until
enough temperature is generated in the flue
system to create a sufficient flue draught. Turn
the control knob to setting 3.
3. After a further ten minutes, turn the control knob
to setting 4. Repeat increasing the control knob
setting in increments of one every ten minutes
until the desired heat setting is reached.

TURNING THE STOVE OFF

When the control knob is turned to 0 from any posi-
tion, the oil feed to the stove is closed and the stove
goes out.
NOTE: ONCE THE STOVE IS TURNED OFF
WHILST IT IS STILL HOT, IT MUST NOT BE RE-
STARTED UNTIL IT HAS COMPLETELY COOLED
DOWN.

POWER FAILURE

A break in the electrical supply while the stove is
lighting will have no effect on the stove. However an
electrical supply is necessary for lighting the stove.

SERVICING

NOTE: ALL WORK SHOULD BE CARRIED OUT
WHEN THE STOVE IS COOL AND THE OIL SUP-
PLY IS TURNED OFF.
The inlet pipe scrubber must be operated at least
once a week (See Fig.21).
1. Loosen the rod fixing nut until the rod can be
moved.
2. Rotate the rod through 360
and out, take care not to push thread in too far
so that it hits the ignition probe.
3. Return the rod to its original position and retight-
en the rod fixing nut.
Fig.21
Fig.20
Every two or three months (depending on use):
1. Remove the fuel bed and the catalyser. Clean
out all carbon deposits in the burner and on the
catalyser (See Fig. 22).
2. Clean the internals of the burner compartment
using a damp cloth.
3. Clean any marks or stains on the viewing glass.
Fig.22
Note: Annual servicing of the stove should only be
undertaken by a fully trained and competent person.
12
o
whilst pushing it in