Message Lists - Sony VPL-HW15 Operating Instructions Manual

Warning messages
Message Cause and Remedy
High temp.! Lamp off in I
~ Turn off the power.
min.
~
Check to ensure that nothing is blocking the ventilation holes.
(@"
page 12)
Frequency is out of range! ~ Frequency is out of range. Input a signal that is within the
acceptable frequency range of the projector.
(@"
page 72)
Please check Input-A
~
Set "Input-A Signal Sel." in the Setup
;II
menu to
Signal Sel.
"Computer" when an ROB signal is input from a computer.
(@"
page 51)
Please replace the Lampl ~ It is time to replace the lamp. Replace the lamp.
(@"
page 65)
Filter. ~ Also, replace the air filter too. Restart cleaning the ventilation
holes (intake).
(@"
page 65)
If this message appears again after you replace the lamp and
filter, the lamp replacement process is not complete. Check the
lamp replacement process.
(@"
page 65)
-
T o clear this message, press any button either on the remote control
or the control panel of the projector once.
Please clean the filter.
~
It is time to clean the air filter. Clean the air filter.
(@"
page 68)
-
T o clear this message, press any button either on the remote control
or the control panel of the projector once.
Please clean the filter. Have
~ It is time to clean the air filter. Clean the air filter.
(@"
page 68)
you finished? Yes No ~
If
you cleaned the air filter, select "Yes." If you did not clean the
air filter, select "No."
Projector temperature is
~ Check to ensure that the ventilation holes on the unit are not
high. Cooling Setting covered.
(@"
page 12)
should be "High" if ~ When using the projector at high altitude, set the Cooling
projector is being used at
Setting to "High".
(@"
page 50)
high altitude.
-
W hen temperature inside the projector remains high, the Cooling
Setting is switched to "High" in I minute, then the fan speed
increases.
Caution messages
Message Cause and Remedy
xE)
~
No signal is input in the selected input. Check connections.
(@"
page 22)
Not applicable! ~ Press the appropriate button.
~ The operation to be activated by the button is currently
prohibited.
64