Sony VPL-HW15 Operating Instructions Manual page 63

The ON/STANDBY or LAMP/COVER indicator lights up or flashes if there is any
trouble with your projector.
ON/STANDBY
LAMP/COVER
i
LAMP/COVER indicator
ON/STANDBY indicator
Symptom Cause and Remedy
LAMP/COVER flashes in ~ Close the lamp cover securely, then tighten the screws securely.
red. (A repetition rate of 2
(CY'
page 66)
flashes) ~ Close the filter holder securely.
(CY'
page 67)
LAMP/COVER flashes in ~
The lamp has reached the end of its useful lifespan. Replace the
red. (A repetition rate of 3 lamp.
(CY'
page 65)
flashes)
~
The lamp has reached a high temperature. Wait until the lamp
cools, and then tum on the power again.
ON/STANDBY flashes in ~ The fan is broken. Consult with qualified Sony personnel.
red. (A repetition rate of 4
flashes)
ON/STANDBY flashes in
~
The internal temperature is unusually high. Check to ensure that
red. (A repetition rate of 2
if nothing is blocking the ventilation holes or whether or not the
flashes) projector is being used at high altitudes.
ON/STANDBY flashes in
~
Press the 1/(9 (ON/STANDBY) switch to tum on the projector. If
red. (A repetition rate of 6 the power is not turned on, disconnect the AC power cord, then
flashes)
confirm the ON/STANDBY lamp is turned off. After about 10
seconds, reconnect the AC power cord and tum on the power
again. If the indicators still light up, the electrical system has a
problem. Consult with qualified Sony personnel.
..
When a warning indicator other than the above starts flashing, and the symptom persists even after
carrying out the above methods, consult with qualified Sony personnel.
63
o
-
~
CD
en