Installation; Electrical Requirements - Kenmore 251-99701-0001 Use And Care Manual

Dehumidifier with wireless remote monitoring station
Hide thumbs Also See for 251-99701-0001:
Table of Contents

Advertisement

Available languages

Available languages

OBSERVE ALL LOCAL CODES AND
ORDINANCES.
DO NOT, UNDER ANY CIRCUMSTANCES,
REMOVE THE POWER SUPPLY CORD
GROUND PRONG.
ELECTRICAL GROUND IS REQUIRED ON
THIS APPLIANCE.
A 115-VOLT 60Hz, AC ONLY, 15A
FUSED AND PROPERLY GROUNDED
ELECTRICAL SUPPLY IS REQUIRED.
A time delay fuse or time delay circuit
breaker is recommended. Use a dedicated
circuit serving only this appliance.
3-prong grounded plug
Power supply cord
DO NOT USE AN EXTENSION CORD.
• Install the dehumidifier on a level floor
strong enough to support the unit with a
full bucket of water.
• For best performance, allow at least 12-
18 inches of air space on all sides of the
unit for good air circulation.
• Keep all outside doors, windows and
other openings closed when operating the
dehumidifier. Humid outdoor air will add to
the unit's workload.
• For maximum efficiency, install your
dehumidifier in an area where the
temperature will not fall below 65°F.

ELECTRICAL REQUIREMENTS

Grounded 3-prong
electrical outlet
INSTALLING YOUR DEHUMIDIFIER
RECOMMENDED GROUNDING METHOD
For your personal safety, this appliance
must be grounded. This appliance has a
power supply cord with a 3-prong grounded
plug. To minimize possible shock hazard,
the cord must be plugged into a matching
grounded electrical outlet that complies with
the latest edition of the National Electrical
Code and all local codes and ordinances.
If a grounded 3-prong electrical outlet is not
available, it is the personal responsibility
and obligation of the customer to have one
installed by a qualified electrician.
ELECTRICAL SHOCK HAzARD
Plug into a grounded 3-prong outlet.
• Do not remove ground prong.
• Do not use a two-prong adapter.
• Do not use an extension cord.
Failure to follow these instructions can result
in death, fire or electrical shock.
• At temperatures below 65°F, the evapor-
ator coils may become covered with frost,
reducing the dehumidifier's performance.
• Leave the dehumidifier in an upright
position for 30 minutes before turning on.
DEFROST OPERATION
The dehumidifier has a built-in defrost
control that senses frost buildup on the
evaporator coils.
During defrosting, the compressor will
automatically turn off; the fan will continue
running to defrost the coils.
4
WARNING

Hide quick links:

Advertisement

Chapters

Table of Contents
loading

This manual is also suitable for:

Elite 251-99701-0001

Table of Contents