Installing And Removing Bits - Hitachi M8V2 Safety Instructions And Instruction Manual

INSTALLING AND REMOVING BITS

WARNING:
1. Installing bits
(1) Clean and insert shank of bit into the collet
chuck until shank bottoms, then back it out
approximately 1/16" (approx. 2 mm).
(2) With the bit inserted and pressing the lock
pin holding the armature shaft, use the 23
mm wrench to firmly tighten the collet chuck
in a clockwise direction (viewed from under
the router). (Fig. 2)
CAUTION:
Ensure that the collet chuck is firmly tightened after inserting a bit. Failure to do so
will result in damage to the collet chuck.
Ensure that the lock pin is not inserted into the armature shaft after tightening the
collet chuck. Failure to do so will result in damage to the collet chuck, lock pin and
armature shaft.
2. Removing bits
When removing the bits, do so by following the steps for installing bits in reverse
order.
CAUTION:
Ensure that the lock pin is not inserted into the armature shaft after tightening a bit.
Failure to do so will result in damage to the collet chuck, lock pin and armature shaft.
Be sure to switch power OFF and disconnect the plug from the
receptacle to avoid serious trouble.
Lock pin
Wrench
Tighten
Fig. 2
English
Loosen
11