Table of Contents
Advertisement
uSINg Your SouNdBAr SYSTEM
TURNING THE SOUNDBAR ON AND OFF
Set the soundbar's Power switcn to the "On" position. Press the Power
button on either the soundbar or the remote to turn the soundbar on.
To put the soundbar in the Standby mode, press either Power button
while the soundbar is on.
Power Button
If you do not press the Power button, the soundbar will automatically
go into the Standby mode approximately 10 minutes after the audio
signal ceases. NOTE: If you have put the soundbar into the Standby
mode by pressing the Power button, you must manually turn it on by
pressing the Power button again. If the soundbar has automatically
gone into the Standby mode 10 minutes after the audio signal has
ceased, it will automatically turn itself on when it receives an audio
signal at either input connection.
If you will be away from home for an extended period of time, or if
you will not be using the soundbar for an extended period, set the
soundbar's Power switch to the "Off" position.
TURNING THE SUBWOOFER ON AND OFF
Set the subwoofer's Power switch to the "On" position. Once the
subwoofer and soundbar have been paired (see Pairing the Units
for Wireless Operation, below) the subwoofer will turn on when the
soundbar turns on and will remain on for approximately one minute
after the soundbar enters the Standby mode, or for approximately 15
minutes after the audio signal ceases.
If you will be away from home for an extended period of time, or if you
will not be using the system for an extended period, set the subwoofer's
Power switch to the "Off" position.
PAIRING THE UNITS FOR WIRELESS OPERATION
After turning the soundbar and subwoofer on for the first time, you will
need to "pair" the subwoofer and soundbar so they both operate at the
same wireless frequency. To pair the units, press the Wireless Pairing
switches on both units within 30 seconds of each other. The units will
communicate with each other and operate at the same frequency.
Soundbar
Pairing Switch
and LED
NOTE: The maximum wireless operating distance between the
soundbar and subwoofer is approximately 50 feet (15.3m).
6
ON-SCREEN INFORMATION DISPLAY
The soundbar's on-screen information display (OSD) will appear on the
screen of a TV connected to the HDMI ARC TV Out connector to verify
operating status. The OSD will overlay on top of the TV's video program
for five seconds after you press a button on the soundbar or remote,
then will disappear. (When you select an audio-only source connection
(Aux, Optical, Bluetooth), the OSD information will overlay a JBL splash
screen.)
Power Button
Overlay
• Mute: When the audio signal is muted, the OSD will display the
following icon:
• Bluetooth: The OSD will disolay the following icons during
Bluetooth operation:
In addition to the status information, the OSD will also display
messages if the selected HDMI connection can't be detected or if the
Subwoofer
Pairing Switch
video signal is lost.
and LED
PHASE
PAIRING
Current
Source
OSD
HDMI 2
Bluetooth Pairing
Bluetooth Connected
Bluetooth Streaming
Bluetooth Not Connected
Volume
Sound
Status
Mode
Music Mode
Hide quick links:
Advertisement
Table of Contents
