Toro TimeCutter MX 4260 Operator's Manual page 43

3
2
1
5
1. Rod
2. Spring
3. Deflector
2. Position the new discharge deflector with the bracket
ends between the welded brackets on the deck as
shown in Figure 57.
3. Install the spring onto the straight end of the rod.
Position the spring on the rod as shown in so the
shorter spring end is coming from under the rod
before the bend and going over the rod as it returns
from the bend.
4. Lift the loop end of the spring and place it into the
notch on the deflector bracket (Figure 58).
g017617
Figure 57
4. Deck brackets
5. Spring installed over the
rod
4
1. Rod and spring assembly
installed
2. Loop end of the spring
installed into the notch in
the deflector bracket
5. Secure the rod and spring assembly by twisting it so
the short end of the rod can be placed behind the
front bracket welded to the deck (Figure 58).
Important: The grass deflector must be spring
loaded in the down position. Lift the deflector
up to test that it snaps to the full down position.
43
2
1
3
4
g017618
Figure 58
3. Rod, short end, moved
behind mower bracket
4. Short end, retained by
mower bracket.