Toro TimeCutter MX 4260 Operator's Manual page 21

Figure 18
1. Smart speed lever
To change speeds:
1. Move the motion control levers to neutral and
outward to the park position; disengage the blade
control switch.
WARNING
Removing your hands from the motion control
levers while the machine is in motion can result
in a loss of control causing harm to you or
bystanders.
Always stop the machine and move the motion
control levers to the park position before
adjusting the Smart Speed™ Control System.
2. Adjust the lever to the desired position.
Forward
1. Move the levers to the center, unlocked position.
2. To go forward, slowly push the motion control
levers forward (Figure 17).
1
G014475
21
Figure 19
To go straight, apply equal pressure to both motion
control levers (Figure 19).
To turn, release pressure on the motion control lever
toward the direction you want to turn (Figure 19).
The farther you move the motion control levers in
either direction, the faster the machine will move in
that direction.
To stop, pull the motion control levers to neutral.
Backward
1. Move the levers to the center, unlocked position.
2. To go backward, look behind you and down as
you slowly pull the motion control levers rearward
(Figure 20).
Figure 20
G008952
G008953