Getting Started - Primo Water 601000 User Manual

If you have questions or issues please contact 1-866-429-7566 for expert assistance.
_______________________________________________________________________________________

GETTING STARTED

To watch videos of the processes noted in this section, please visit www.primowater.com.
Locate Dispenser
1. Place dispenser upright.
Notice: To avoid damage to compressor, allow dispenser to sit upright at least 45 minutes before proceeding.
2. Locate dispenser on a hard and level surface in a cool shaded location near a grounded wall outlet.
Notice: Do NOT plug in power cord yet.
3. Position dispenser so the back is at least 4 inches from wall and there are at least 4 inches of clearance on both
sides.
4. Level dispenser by raising and lowering feet. Turn clockwise to raise height and counterclockwise to lower.
Install Drip Tray
1. To install Drip Tray, align pegs with holes and gently push down into place.
Install Water Bottle
1. Open dispenser door.
2. Place probe assembly on probe hanger.
3. Place fresh bottle outside of cabinet.
4. Remove entire plastic cap from top of bottle.
5. Clean outside of new bottle with a cloth.
6. Place probe into bottle.
7. Slide collar down until it clicks in place.
8. Push head down until tubes hit bottom of bottle.
9. Slide bottle into cabinet and close door.
Provide Electricity
1. Plug cord into a properly grounded wall outlet.
2. At this time:
a. The lights on the dispenser will go through a test pattern. When complete the lock icon will be green,
indicating there is power.
b. The pump will begin to move water from the bottle to the hot and cold tanks. It will take up to 20 minutes to
fill the tanks for the first time. During this period the pump will run continuously. This is normal.
Please visit www.PrimoWater.com for more useful information, instructional videos, tips and special offers.
IMPORTANT: Do Not Return Dispenser to Store.
Page | 4