Related Manuals for HAMPTON BAY Northport 178-047
Summary of Contents for HAMPTON BAY Northport 178-047
- Page 1 178 047 Northport Ceiling Fan Owner’s Manual Northport Ventilador de Techo de 1,32 Manual del Propietario...
- Page 2 Northport by Hampton Bay ®...
-
Page 3: Table Of Contents
52” Northport Thank you for purchasing our ceiling fan. This product has been manufactured with the highest standards of safety and quality. Ceiling Fan by Hampton Bay Date Purchased Table of Contents Store Purchased Safety Rules ....1 178-047 UL Model No. -
Page 4: Safety Rules
Safety Rules - Read and Save These Instructions To reduce the risk of electric shock, insure electricity has been turned off After making electrical connections, spliced conductors should be turned at the circuit breaker or fuse box before beginning. upward and pushed carefully up into outlet box. The wires should be spread apart with the grounded conductor and the equipment-grounding All wiring must be in accordance with the National Electrical Code conductor on one side of the outlet box and ungrounded conductor on the... -
Page 5: Unpacking Your Fan
Unpacking Your Fan Unpack your fan and check the contents. You should have the following items: Set of blades (4) Fan motor assembly Electrical Hardware (3 Plastic Wire Nuts) Canopy assembly Light kit mounting plate Standard Ball/downrod assembly Light kit assembly Blade Attachment Hardware Minimum-length downrod (for close to Glass shade... -
Page 6: Installing Your Fan
Installing Your Fan Provide Strong Support Tools Required Figures 1~3 are examples of different ways to mount the outlet box. Phillips screwdriver, straight slot screwdriver, step ladder and wire cutters. Recessed Ceiling Outlet Box Mounting Plate Mounting Options Figure 3 Outlet Box Note: You may need a longer downrod to If there isn't an existing UL listed mounting box,... - Page 7 Hanging the Fan WARNING Cross Pin FAILURE TO PROPERLY INSTALL COTTER PIN AS NOTED IN STEP 5 COULD RESULT IN REMEMBER to turn off the power. Follow the Hanger Ball FAN LOOSENING AND POSSIBLY FALLING. steps below to hang your fan properly. Downrod Remove the canopy cover from the canopy by turning the cover counter clockwise.
- Page 8 Installing Fan to the Motor Wires UL Listed Outlet Box Electrical Box Cross Pin Hanger Ball Set Screw WARNING Downrod 120V TO REDUCE THE RISK OF FIRE, ELECTRIC Ceiling Canopy Wires SHOCK OTHER PERSONAL INJURY. MOUNT FAN ONLY TO AN OUTLET BOX OR SUPPORTING SYSTEM MARKED ACCEPTABLE Canopy Bottom FOR FAN SUPPORT AND USE THE MOUNTING...
- Page 9 Making the Electrical blue wire will be on the other side, and push SUPPLY CIRCUIT carefully up into the outlet box. Connections WARNING Ground CHECK TO SEE THAT ALL CONNECTIONS ARE REMEMBER to disconnect the power. Conductor TIGHT, INCLUDING GROUND, AND THAT NO BARE WIRE IS VISIBLE AT THE WIRE NUTS.
-
Page 10: Attaching The Fan Blades
Finishing the Fan Attaching the Fan Blades Outlet Box Installation Insert the blade through the slots in the bottom Hanger band. (Fig. 14) Bracket Tuck connections neatly into ceiling outlet Screw Align the holes from the blade to the holes in box. -
Page 11: Blade Balancing
Blade Balancing Attaching the Light Kit Mounting Plate The following procedure should correct most fan Touching Ceiling wobble. Check after each step. Remove the 1 of 3 screws from the mounting ring and loosen the other 2 screws. (Do not Check that all blade and blade holder screws remove) are secure. -
Page 12: Installing The Light Kit
Installing the Light Kit CAUTION Install 1 x 75 watts halogen bulb (included) BEFORE STARTING INSTALLATION, DISCON- into the light sockets. NECT THE POWER BY TURNING OFF THE CIRCUIT BREAKER OR REMOVING THE FUSE Raise glass shade up against light kit and AT FUSE BOX. -
Page 13: Operating Your Fan
Operating Your Fan NOTE WAIT FOR FAN TO STOP BEFORE REVERSING THE DIRECTION OF THE BLADE ROTATION. Turn on the power and check the operation of your fan. There are two pull chains available in your fan: 1. 3-speed pull chain- it controls the fan speed as follows: 1 pull- High, 2 pulls- Medium, 3 pulls- Reverse Low, and 4 pulls- Off. -
Page 14: Care Or Your Fan
Care of Your Fan Troubleshooting PROBLEM SOLUTION Here are some suggestions to help you maintain your fan. Fan will not start Check main and branch circuit fuses or breakers. Because of the fan's natural movement, some Check line wire connections to the fan and switch wire connections in connections may become loose. -
Page 15: Specifications
Specifications FAN SIZE SPEED VOLTS AMPS WATTS N.W. G.W. C.F. 0.18 1777.27 7.13 kgs 8.00 kgs 52” MED. 0.30 27.5 3383.09 1.45’ (15.69 lbs) (17.60 lbs) 0.39 4740.71 HIGH These are approximate measures. They do not include Amps and Wattage used by the light kit. Distributed by Your Other Warehouse, LLC 12100 Little Cayman Dr. -
Page 16: Warranty Information
Lifetime Limited Warranty (lifetime warranty on motor) The Hampton Bay warrants the fan motor to be free from defects in workmanship and material present at time You must present a copy of the original purchase receipt to obtain warranty of shipment from the factory for a period of lifetime after the date of purchase by the original purchaser.