Bridged Mono Operation - Linear Power 5002 Owner's Manual And Installation Manual

5.The red and white wire acts as an electrical switch to turn the amplifier on and
off. It should be connected to the power antenna lead from the radio. Where no
power antenna lead exists, a source of 12 volts, connected through a toggle
switch, will do. Do not connect directly to a source that will leave the amplifier
permanently on as this will drain the battery.
6.The RCA (phono) jacks will accommodate either high or low level signals,
ranging from 200mv to 5 volts. For low-level signals, always use shielded cable
and avoid routing signal cables in the vicinity of any power wires. The center pin
of the RCA plug is ALWAYS the positive input connection.
7. As shipped from the factory, the Model 5002 will be set up as a normal
©
stereo amplifier, with the Dynamics Improving Processor off, and ready for a
©
4 ohm stereo load on each channel. If you wish to engage one of the optional
functions of this amplifier, remove the main power fuse to avoid the risk of
electrical shock from the high voltage present inside the case of the amp, then
remove the bottom cover. The speaker connections are (from left to right, with
the amp fins up, connector plate facing you): LEFT (-), LEFT (+), RIGHT (+),
RIGHT (-).

BRIDGED MONO OPERATION

Locate the switch marked,"Stereo/Bridged." Move to "Bridged" position. The
left positive speaker wire is now the + speaker output, with the right positive
speaker wire becoming the - speaker output. The two negative speaker outputs
will not be used. The amplifier will now operate as a bridged mono amplifier.
Please observe the correct impedance loads, stereo and bridged for this
amplifier!
TWO-OHM CAPABILITY
© 2008 Linear Power, Inc. - ALL RIGHTS RESERVED 3
LINEAR POWER™ is a trademark of Linear Power, Inc.