Download Print this page

Linear Power 502HV Owner's Manual And Installation Manual

Linear power 502hv amplifier is a 25-watt per channel amplifier

Advertisement

Quick Links

F O
A new approach in competition amplifiers is here...The LINEAR POWER™
502HV
amplifier is a 25-watt per channel amplifier with extremely low distortion
©
and lots of dynamic headroom. We have utilized TO-3 transistors throughout the
amplifier for the highest reliability and unmatched sound quality.
LINEAR POWER™ designers and engineers listened to the suggestions of
seasoned competitors to find the right foundation for this amplifier. We chose an
amplifier that has been tried and tested in challenging situations. We then took
the next step of deciding on an operating format that went against conventional
competition designs. LINEAR POWER™ engineers were convinced that the HV
(HIGH VOLTAGE) competition amplifier would be much more stable and
controllable, establishing high damping factor and unmatched dynamic
headroom, than ANY high current design amp. Distortion at rated power is
extremely low and the unregulated power supply is capable of delivering serious
output when needed - NOT to extremely low impedances - but to higher
impedances where sound quality can be assured. This can be done due to
the extreme HIGH VOLTAGE design of the HV
have low impedance loads to stress the amplifier to make power. The minimum
operating impedance of the 502HV
eliminating the need for multiple drivers to lower the impedance load to get
maximum power output. A benefit of HIGH VOLTAGE design is less heat and
lower current draw from your electrical system, at the same time, delivering the
power that you want.
Features include the LINEAR POWER™ DYNAMICS IMPROVING
PROCESSOR
or D.I.P. "Bass Boost" switch, which adds 6dB of gain at 45 Hz
©
for that additional 'OOMPH', if needed. The 502HV
so that the amp will bridge without he use of an internal bridge switch or external
bridging module. This inverted channel also allows the 502HV
stereo/mono mode simultaneously. With all the 502HV
final element needed to dominate competitions.
R
T H E
L
O
MODEL 502HV
(1996 - MSRP $1099)
OWNER'S MANUAL AND

INSTALLATION GUIDE

502HV
COMPETITION CHALLENGER
©
is 2 ohms stereo or 4 ohms mono,
©
© 2008 Linear Power, Inc. - ALL RIGHTS RESERVED
LINEAR POWER™ is a trademark of Linear Power, Inc.
V
E
O
F
M
U
©
amplifier. There is no need to
©
also has an inverted channel
©
©
delivers, it could be the
©
S
I
C
©
to play in
1

Advertisement

loading

Summary of Contents for Linear Power 502HV

  • Page 1: Installation Guide

    INSTALLATION GUIDE 502HV COMPETITION CHALLENGER © A new approach in competition amplifiers is here...The LINEAR POWER™ 502HV amplifier is a 25-watt per channel amplifier with extremely low distortion © and lots of dynamic headroom. We have utilized TO-3 transistors throughout the amplifier for the highest reliability and unmatched sound quality.
  • Page 2 This "bass boost" is a carefully measured EQ curve to enhance performance if needed. The boost occurs at 45 Hz. © 2008 Linear Power, Inc. - ALL RIGHTS RESERVED LINEAR POWER™ is a trademark of Linear Power, Inc.
  • Page 3: Operation / Adjustment

    2.The case of your amplifier is designed to act as a noise shield. To maintain this protection, be sure the metal case of the amp does not touch the metal of the © 2008 Linear Power, Inc. - ALL RIGHTS RESERVED LINEAR POWER™ is a trademark of Linear Power, Inc.
  • Page 4: General Troubleshooting

    To avoid damage to the speakers, turn volume to a minimum while waiting for the amp to turn itself back on. SERVICE OR REPAIR To obtain service or repair, please contact our authorized LINEAR POWER product service center: T.I.P.S. INC.
  • Page 5: Specifications

    3 4 5 5 L A N E L L L A N E, P E A R L, M S 3 9 2 0 8 (6 0 1) 9 3 2 – 8 4 7 7 © 2008 Linear Power, Inc. - ALL RIGHTS RESERVED...