Auto Mode - Carrier Elite Plasma Green 53QHET12-708J Owner's Manual

USE OF REMOTE CONTROL (Cont.)

AUTO MODE

START
1. Press MODE button to select AUTO mode
on the remote control display.
2. Press TEMP buttons
set temperature on the remote control display.
Set desired temp. between 17°C to 30°C .
3. Press ON/OFF button to start
the air conditioner.
ON symbol
remote control display.
OPERATION led will illuminate
on the display panel of indoor unit.
AUTO mode led AUTO will illuminate
on the display panel of the indoor unit.
AUTO mode starts after approximately 3 minutes
and Plasma operates for refeshing air, removing
smoke and dust particles. Plasma gives an
immediate sensation of energy and well-being.
STOP
If you want to stop the air conditioner,
Press ON/OFF button again.
NOTES
1. For Heat Pump System
When Auto mode is activated, the air conditioner changes the operation mode automatically to
cool or heat or fan only mode and also changes fan speed to auto speed by sensing the
temperature difference between room temperature and set temperature.
2. For Cool Only System
When Auto mode is activated, the air conditioner changes the operation mode automatically to
cool or fan only mode and also changes fan speed to auto speed by sensing the temperature
difference between room temperature and set temperature.
3. In the Auto mode, you cannot switch the fan speed. It has already been automatically controlled.
4. If the Auto mode is not comfortable for you , the desired mode can be selected manually.
5. If the ECO function is activated when the unit is operating in Auto mode, the fan speed will
change into Low speed mode immediately.
or to select the
appears on the
1
3
( 11 )
2
2