Removal Of Dvd Deck Parts - Toshiba 17HLV85 Service Manual

2. REMOVAL OF DVD DECK PARTS

2-1: LOADING MOTOR ASS'Y/START SW PCB ASS'Y/
END SW PCB ASS'Y (Refer to Fig. 2-1-A)
Remove the 3 screws 1.
1.
2. Remove the Loading Motor Ass'y.
Remove the 2 screws 2.
3.
4. Remove the Motor and Loading Worm.
5. Disconnect the following connector: (CP2).
Remove the screw 3.
6.
Unlock the 2 supports 4 and remove the Start SW PCB
7.
Ass'y.
Unlock the 2 supports 5 and remove the End SW PCB
8.
Ass'y.
1
1
Motor
Loading Worm
2
4
4
• Screw Torque: 1 ± 0.2kgf•cm
NOTE
1. In case of the Loading Worm installation, check if the
value of the Fig. 2-1-B is correct.
2. When installing the wire, install it correctly as Fig. 2-1-B.
Loading Worm
Motor
Safety surface for pressing
of the insert.
Start SW PCB Ass'y
Black
Red
DISASSEMBLY INSTRUCTIONS
1
Loading Motor Bracket
2
3
Start SW PCB Ass'y
End SW PCB Ass'y
5 5
Fig. 2-1-A
29.7 ± 0.1mm
Fig. 2-1-B
End SW PCB Ass'y
Red
Black
Motor
Fig. 2-1-C
2-2: TRAVERSE UNIT ROD/TRAVERSE UNIT HOLDER/
CD DECK/INSULATOR (Refer to Fig. 2-2)
Remove the screw 1.
1.
2. Remove the Traverse Unit Rod.
Remove the 2 screws 3.
3.
Unlock the 2 supports 4 and remove the CD Deck Block.
4.
Remove the 2 screws 5.
5.
Unlock the 2 supports 6 and remove the Traverse Unit
6.
Holder.
7. Remove the 4 Insulators.
Traverse Unit Holder
Insulator
4
Traverse Unit Rod
• Screw Torque: 3 ± 0.5kgf•cm
2-3: MOUTH ASS'Y (Refer to Fig. 2-3)
Remove the 2 screws 1.
1.
2. Remove the Mouth Ass'y.
1
Mouth Ass'y
• Screw Torque: 0.8 ± 0.2kgf•cm
B2-1
2
Insulator
5
2
5
CD Deck
Insulator
4
1
3
3
1
Insulator
Fig. 2-2
Fig. 2-3