Removal Of Dvd Deck Parts - Toshiba MD14FN1 Service Manual

2. REMOVAL OF DVD DECK PARTS

NOTE
1. Do not disassemble the DVD DECK PARTS except listed
parts here. Minute adjustments are needed if the disas-
semble is done. If the repair is needed except listed parts,
replace the DVD MECHA ASS'Y.
2-1: TRAY (Refer to Fig. 2-1-A)
1. Set the Tray opened. (Refer to the DISC REMOVAL
METHOD AT NO POWER SUPPLY)
Unlock the support 1 and remove the Tray.
2.
1
Tray
NOTE
1. In case of the Tray installation, install them as the circled
section of Fig. 2-1-B so that the each markers are met.
Main Frame Ass'y
2-2: MAIN CHASSIS ASS'Y (Refer to Fig. 2-2-A)
1. Remove the Main Chassis Ass'y from the Insulator (R).
Unlock the support 1.
2.
3. Remove the Main Chassis Ass'y.
Main Frame Ass'y
Main Chassis Ass'y
NOTE
1. In case of the Main Chassis Ass'y, install it from (1) to (6)
in order. (Refer to Fig. 2-2-B)
DISASSEMBLY INSTRUCTIONS
Main Frame Ass'y
Fig. 2-1-A
Tray
Fig. 2-1-B
Insulator (R)
(Green)
1
Fig. 2-2-A
Rack Loading
Move it to the direction
of the arrow.
Main Frame Ass'y
2-3: RACK LOADING/MAIN GEAR/ RACK LOADING
SPRING (Refer to Fig. 2-3)
Press down the catcher 1 and slide the Rack Loading.
1.
2. Remove the Rack Loading, Rack Loading Spring and
Main Gear.
Rack Loading Spring
1
2-4: CLAMPER ASS'Y/INSULATOR(R)/LEVER SWITCH
(Refer to Fig. 2-4-A)
Remove the screw 1.
1.
2. Remove the Lever Switch.
3. Remove the 2 Insulator (R).
4. Press the Clamper and rotate the Clamper Plate clockwise,
then unlock the 3 supports 2.
5. Remove the Clamper Plate, Clamper Magnet and Clamper.
Clamper Plate
Clamper Magnet
Lever Switch
B2-1
Main Chassis Ass'y
1
2
6
3
4
5
Rack Loading
Main Gear
Main Frame Ass'y
Insulator (R)
(Green)
Insulator (R)
(Green)
Main Frame
2 2
1
Clamper
2
6
Check Lock
4
5
Fig. 2-2-B
Fig. 2-3
Fig. 2-4-A