When Replacing Dvd Deck - Toshiba 17HLV85 Service Manual

[ When removing the DVD Deck ]
Before removing Pick Up PCB and DVD PCB connector, the short circuit the position shown in Fig. 1
using a soldering iron. If you remove the DVD Deck with no soldering, the Laser may be damaged.
[ When installing the DVD Deck ]
Remove all the soldering on the short circuit position after the connection of Pick Up PCB and DVD
PCB connector.
NOTE
• Before your operation, please read "PREPARATION OF SERVICING".
• Use the Lead Free solder.
• Manual soldering conditions
• Soldering temperature: 320 ± 20˚C
• Soldering time: Within 3 seconds
• Soldering combination: Sn-3.0Ag-0.5Cu
• When Soldering/Removing of solder, use the draw in equipment over the Pick Up Unit to keep the
Flux smoke away from it.
Short circuit using a
soldering iron.

WHEN REPLACING DVD DECK

Pick Up PCB
Fig. 1
A1-6