[ When removing the DVD Deck ]
Before removing Pick Up PCB and DVD MT PCB connector, short circuit the position shown in
Fig. 1 using a soldering iron. If you remove the DVD Deck with no soldering, the Laser may be
damaged.
[ When installing the DVD Deck ]
Remove all the soldering on the short circuit position after the connection of Pick Up PCB and
DVD MT PCB connector.
NOTE
•
Before your operation, please read "REPARATION OF SERVICING".
•
Use the Lead Free solder.
•
Manual soldering conditions
• Soldering temperature: 320 ± 20
• Soldering time: Within 3 seconds
• Soldering combination: Sn-3.0Ag-0.5Cu
•
When Soldering/Removing of solder, use the draw in equipment over the Pick Up Unit to keep the
Flux smoke away from it.
WHEN REPLACING DVD DECK
o
C
Circuit bridge points
Pick Up PCB
Fig.1
A1-2
19DV550P/19DV551P