Miele T 8826 WP Operating Instructions Manual page 35

Problem
The Clean the filters
indicator light comes on
at the end of the
programme.
The Empty container
indicator light comes
on.
The buzzer sounds.
The Start/Stop button is
flashing slowly and the
display is dark.
The Start/Stop button
flashes/does not flash.
Possible cause
This is a reminder to
clean the fine filter in front
of the heat exchanger unit
under running water.
The condensed water
container is full or there is
kink in the drain hose.
The dryer is in Standby
mode.
This is quite normal and
not indicative of any fault.
The flashing indicates
that a programme can be
started.
Problem solving guide
Remedy
– Clean the fine filter.
See "Cleaning and
care".
To switch off this
reminder:
– Switch the dryer off
and then back on
again.
– Open and shut the
door with the dryer
switched on.
– Empty out the
condensed water
container.
– Check the drain hose.
To switch off this
warning:
– Open and close the
door.
See "Programmable
functions".
After the programme has
started, the flashing will
change to a constant
light.
35