Table of Contents
Advertisement
1.
GENERAL DELIVERY
NOTES
The machine and all parts are generally delivered in
palletized cartons. Upon receipt check that:
1. All packaging is intact.
2. The contents are the:
a. Machine.
b. Box of accessories:
b0. Two-cup filter b1. Filter spring
b2. Filter holder
b4. Coffee measure
b5. Coffee press b6. Single-cup filter
3. The machine and accessories are not damaged in
any way.
In case of damage or missing pieces, immediately
contact the manufacturer or its sales agent in your
area or its insurance company.
2.
SAFETY
INDICATIONS
The present manual is an integral and
essential part of the product and is to be
delivered to the user. Carefully read all
warnings in the manual as they provide
important information required to install,
use and maintain the unit safely. Keep this
manual in a safe place for further consul-
tation.
After having removed the packaging,
make certain that the unit is not damaged
in any way.
If you have any doubts, do not use the
unit and contact a professionally qualified
person.
Always keep all packaging (plastic bags,
polystyrene foam, nails, etc.) out of the
reach of children as they are a potential
source of danger and never loiter the
environment with such materials.
DANGEr OF POLLUTION
Before turning on the unit make certain that
the rating indicated on the label matches the
available power supply. The label is located
under the machine work base at the upper
right.
Installation must be performed following the
standards in force in the country where it is
being installed and following the manufac-
turer's instructions. Only skilled personnel
can install this unit.
The manufacturer cannot be held responsi-
ble for any damages incurred if the system is
not grounded.
For electrical safety, this machine requires a
ground system. Contact a technically certi-
fied electrician who must check that the line
electrical capacity is adequate for the maxi-
mum capacity indicated on the unit label.
The electrician must also check that the
line cables have adequate section to han-
dle the power absorbed by the unit.
Never use adapters, multiple jacks or
extension cords. When such items prove
absolutely necessary, call in a qualified
electrician.
When installing the device, it is necessary
to use the parts and materials supplied
with the device itself. Should it be neces-
sary to use other parts, the installation
engineer needs to check their suitability
for use in contact with water for human
consumption.
The machine must be installed in compli-
ance with the local health standards in
force for plumbing systems. Therefore,
contact an authorized plumber.
Fig. 1
The device needs to be supplied with
water that is suitable for human consump-
tion and compliant with the regulations in
force in the place of installation. The
installation engineer needs confirmation
from the owner/manager of the system
that the water complies with the require-
ments and standards stated above.
This unit must only be used for the pur-
poses described in the present manual.
The manufacturer cannot be held respon-
sible for any damages caused by improp-
er, mistaken and unreasonable use.
The appliance is not to be used by chil-
dren or persons with reduced physical,
sensory or mental capabilities, or lack of
experience and knowledge, unless they
have been given supervision or instruc-
tion.
This appliance is for professional use
only.
The operating temperature must be within
the range of [+5, +35]°C.
At the end of installation, the device is
Fig. 2
switched on and taken to rated operating
conditions, leaving it in a state in which it
is "ready for operation".
The device is then switched off and the
whole hydraulic circuit is bled of the first
lot of water in order to remove any initial
impurities.
The device is then refilled and taken to
rated operating conditions.
17
Hide quick links:
Advertisement
Table of Contents
