Kenwood KNA-G510 Instruction Manual page 57

12 parallel channel GPS receiver
1,575.42 MHz
I Acquiring GPS Signals
The first time you turn on the KNA-G51O, you must wait while the system acquires satellite signals for the first time. This
process could take up to several minutes. Make sure your vehicle is outdoors in an open area away from tall buildings
and trees for fastest acquisition. After the system acquires satellites for the first time, it will acquire satellites quickly each
time thereafter.
Changing the Fuses
If you need to replace a fuse on the red or yellow wires, make sure the wires are not touching to prevent a short circuit.
Then replace the old fuse with a new 2 Amp fuse.
Caution
When replacing a fuse, use only a new fuse with the prescribed rating. Using a fuse with the wrong rating may
cause your unit to malfunction. Disconnect the wiring harness before replacing a fuse to prevent short circuits.
Information in this document is subject to change without notice.
Specifications
General
Operating Temperature: -15°C to 70°C
Storage Temperature: -40°C to 85°C
Operating Voltage: 9.5 V to 25 V
Current Consumption: 0.12A typical at 13 V (Max 1.0Aat 13 V)
ACC off Current: 70 uA typical at 13 V
Dimensions: 1
3
/ 16 "
H x 4
3//
W x 4
Sfa"
L (30 mm x 120 mm x 117 mm)
Weight: 0.41Ib(184g)
Map Storage: Internal non-removable memory (pre-loaded City Navigator map data) and optional removable SO card
Connectors: System/power, GPS antenna, SO card slot, Mini-B for optional XM or FM traffic receivers
Navigation
Receiver:
Frequency:
Acquisition Times:
Warm: Approx. 15 seconds
Cold: Approx. 45 seconds
AutoLocate®: Approx. 2 minutes
Update Rate: 1/second, continuous
GPS Accuracy: 15 meters (49 feet) RMS 95% typical with GPS
DGPS (WAAS) Accuracy: < 3 meters (10 tt) 95% typical with OGPS (WAAS/EGNOS) corrections
Antenna: external GPS antenna