Table of Contents
Related Manuals for Kenwood KNA-G610
Summary of Contents for Kenwood KNA-G610
- Page 27 Failure to avoid the following potentially hazardous situations could result in serious injury or ¿ re. Do not attempt to install or service the KNA-G610 by yourself. Installing or servicing the unit without training and experience in electronic equipment and automotive accessories may be dangerous and could expose you to the risk of electric shock or other hazards.
-
Page 28: Installing The Main Unit
What’s Included GPS antenna and main unit M3 x 12 machine M3 x 12 thread- wiring harness metal plate screws (4) forming screws (4) M3 nuts (4) hook-and-loop owner’s manual installation manual warranty card caution card fasteners (2) Installing the Main Unit Use the screws or the hook-and-loop fasteners provided to mount the main unit in the vehicle. - Page 29 You can bend the metal plate to conform to a curved surface, if necessary. 4. Place the GPS antenna on top of the metal plate. Steps to Install the KNA-G610 1. Remove the key from the vehicle ignition and disconnect the negative battery cable.
-
Page 30: Acquiring Gps Signals
Acquiring GPS Signals The ¿ rst time you turn on the KNA-G610, you must wait while the system acquires satellite signals for the ¿ rst time. This process could take up to several minutes. Ensure that your vehicle is outdoors in an open area, away from tall buildings and trees, for fastest acquisition.