Starting; Apply Chemicals And Cleaning Solvents - Excell XR2600 Operation Manual

HOW TO APPLY CHEMICALS
AND CLEANING SOLVENTS
Applying chemicals or cleaning
solvents is a low pressure operation.
NOTE: Use only soaps and chemicals
designed for pressure washer use. Do
not use bleach.
To Apply chemicals:
1. Press chemical
hose onto barbed
fitting located
near high
pressure hose
connection of
pump as shown.
2. Place other end of chemical hose
with filter on it into container
holding chemical/cleaning solution.
NOTE: For every 7 gallons of water
pumped 1 gallon of
chemical/cleaning solution will be
used.
3. Install low pressure (black) nozzle
into quick connect fitting of spray
wand, see How To Use Spray
Wand paragraph in this section.
4. After use of chemicals, place
chemical hose into container of
clean water and draw clean water
through chemical injection system
to rinse system thoroughly. If
chemicals remain in the pump it
could be damaged. Pumps
damaged due to chemicals will not
be covered under warranty.
NOTE: Chemicals and soaps will not
siphon when spray wand is in the high
pressure setting.
A00034

STARTING

Prior to starting, refer to your engine
manual for proper starting
procedure.
1. In a well ventilated outdoor area
add fresh, high quality, unleaded
gasoline with a pump octane
rating of 86 or higher. Do not
overfill. Wipe up spilled fuel before
Barbed starting the engine. Refer to
Fitting
Engine Owners Manual for correct
procedure.
2. Check engine oil level. See
Engine Owners Manual for correct
procedure.
3. Verify the
filter screen is
in water inlet of
pump. NOTE:
Cone side
faces out.
4. Connect water
source to pump inlet.
NOTE: Water source must provide a
minimum of 5 gallons per minute at
20 PSI.
5. Connect high pressure hose to
pump outlet.
6. If applying a chemical or
cleaning solution, see How To
Apply Chemicals/Cleaning
Solvents instructions in this
section.
7. Turn water source on. NOTE:
Failure to do so could cause
damage to the pump.
10- ENG
Filter Screen
Water
Source
High Pressure
Hose Hook-up