HPS500/1000 OM
10/25/99
NOTE: Some receivers have a single
subwoofer output (do not confuse this
with a single LFE output as described
below). In that case, it is recommended
that you use a Y connector (not included)
to maximize performance.
NOTE: In this case, you do not need to
use a Y connector. Simply connect the
LFE output on your receiver/processor
to either the left or right input on
2:40 PM
Page 10
C
ONNECTING
If your receiver/processor has subwoofer outputs for the left and right channels:
If you have a Dolby* Digital or DTS
(LFE) output:
the subwoofer.
Y
S
OUR
UBWOOFER
LOW
LOW
LEVEL
LEVEL
OUT
IN
L
HIGHPASS
OUTPUT
120Hz
R
160Hz
80Hz
®
receiver/processor with a low-frequency-effect
SUBWOOFER OR
LFE OUTPUT
LOW
LOW
LEVEL
LEVEL
OUT
IN
L
HIGHPASS
OUTPUT
120Hz
160Hz
R
80Hz
(Continued)