Frigidaire CMSF-1/0310 Important Instructions & Operating Manual page 3

21. Faulty wall outlet connections may cause the wall outlet to overheat. Be sure that fireplace plug fits
tightly into outlet before each use. During use, check to make certain the fireplace plug is not
overheating. If necessary, have a qualified electrician check and / or replace the wall outlet.
22. Do not place the fireplace near a bed, as objects such as pillows or blankets can fall off the bed and
be ignited by the fireplace.
23. Never clean this fireplace while it's plugged in. To disconnect, turn control to OFF, then remove the
plug from the outlet. Never pull the cord. Always hold the plug firmly & remove from the outlet.
24. This fireplace is intended for supplemental heat and / or decorative purposes. Continuous use for
several hours can impact the performance & life of the fireplace.
25. It is not intended to be used in commercial, industrial or agricultural settings.
26. Do not use outdoors.
Getting Started

Remove the fireplace from the box.

Remove all the packaging and place it inside the box and either store or dispose of safely.
Package Contents

Electric Fireplace

Instruction Manual
Features

Log Wood Flame Effect

2 Heat Settings

Auto Thermal Cut Out

Operates With & Without Heat
Quick Reference Guide

Prior to installation, please ensure that your power-outlet is suitable for your fireplace against
both voltage and capacity.

Your fireplace may emit a slight, harmless odor during its first use. This odor is a normal
condition caused by the initial heating of internal fireplace parts and it will not occur again.

It is normal for fireplace to make rattling sound for a short duration of time, during its first use.

If your fireplace does not emit heat, please ensure the fireplace Switch is on. For further
information, please refer to Troubleshooting section of this manual.
Helpful Advice Before Installation

Please retain all packaging until you have checked and counted all the parts and other package
contents.
 It is recommended to place your fireplace near an existing outlet, for ease of electric connection.

Store your fireplace in a dry, safe and dust-free place while drilling, for fireplace installation.

Do not attempt to wire new outlets or circuits. To reduce the risk of fire, electric shock or injury
to persons, always have a licensed electrician perform maintenance and other repairs.