EverFocus EPTZ Series User Manual page 12

Analogue IR speed dome series
Note: The factory default address is 1.
Notice: Please make sure the power is off before setting, and restart the EPTZ860 to enable a
new value after changing.
Note: You will see the label of Protocol & Baud Rate as well as RS-485 ID address show on the
speed dome. White part represents the switch key. For example: for EVF protocol, white keys are
all switched downward; for ID Address 0, white keys are all switched downward.
Settings of SW2
The 1st-3rd DIP Switch are for reserved .The 4th and 5th DIP set the Baud rate, factory-default
setting is 2400bps(Baud rate: 1200bps, 2400bps, 4800bps, 9600bps selectable)
The 8th bit of DIP switch SW2 is to select the matching resistor.
12