Download Print this page
King Canada 8510LP Instruction Manual

King Canada 8510LP Instruction Manual

Wet-dry vacuum

Advertisement

Quick Links

KING CANADA
WET•DRY VACUUM
MODEL: 8510LP

INSTRUCTION MANUAL

COPYRIGHT © 2007 ALL RIGHTS RESERVED BY KING CANADA TOOLS INC.

Advertisement

loading

Summary of Contents for King Canada 8510LP

  • Page 1: Instruction Manual

    KING CANADA WET•DRY VACUUM MODEL: 8510LP INSTRUCTION MANUAL COPYRIGHT © 2007 ALL RIGHTS RESERVED BY KING CANADA TOOLS INC.
  • Page 2: Warranty Information

    Warranty does not apply to defects due directly or indirectly to misuse, abuse, negligence or accidents, repairs or alterations and lack of maintenance. KING CANADA shall in no event be liable for death, injuries to persons or property or for incidental, special or consequential damages arising from the use of our products.
  • Page 3: Getting To Know Your Vacuum

    POWER SUPPLY- WARNING: YOUR VACUUM MUST BE SPECIFICATIONS CONNECTED TO A 110V, MINIMUM 15-AMP. BRANCH CIRCUIT. FAILURE TO CONNECT IN THIS WAY CAN RESULT IN INJURY Model................8510LP FROM SHOCK OR FIRE. Voltage................110V Horsepower ............2 HP (peak) GROUNDING- Your vacuum must be properly grounded. Not all outlets Amperage ................6A...
  • Page 4 UNPACKING, ASSEMBLING & OPERATING YOUR VACUUM ATTENTION! The vacuum accessories are packed inside the vacuum tank. UNPACKING YOUR VACUUM Remove the entire contents of the carton, please note that most of the accessories are packed inside the vacuum tank. To access these accessories, turn the cover latches (A) Fig.3 backwards, remove the tank cover/motor assembly and then remove the accessories inside the tank.
  • Page 5: Operation

    OPERATION 6) Plug the power cord to a power source. 7) Start the vacuum by pushing the On/Off water proof switch to the On position as shown in Fig.8. The On position is indicated by the international symbol “I” on the switch. 8) Once the vacuuming operation is finished, push the switch to the Off position indicated by the international symbol “O”...
  • Page 6: Operation And Maintenance

    Reduced efficiency/increased motor speed- Inlet is block or tank is full- Unblock inlet or empty tank. PARTS DIAGRAM & PARTS LISTS Refer to the Parts section of the King Canada web site for the most updated parts diagram and parts list.