Download Print this page

Operation And Maintenance - King Canada 8510LP Instruction Manual

Wet-dry vacuum

Advertisement

BLOWER FEATURE
This vacuum can be used as a powerful blower. To use the blower feature, disconnect the hose
from the inlet and reconnect it to the blower outlet (A) as shown in Fig.13. Turn the vacuum On,
your vacuum is now a blower to clear work tables of debris, blow leaves etc...
STANDARD AND OPTIONAL ACCESSORIES
The following chart lists the standard accessories included and the available optional
accessories for this wet•dry vacuum. Please note that these accessories are not covered under
warranty and are available at your nearest King Canada distributor.
Model
Description
KVAC-1030
Foam Filter- 1pc.
KVAC-1050
Re-usable Filter- 1pc.
KVAC-1090
5ft. x 1-1/4" Flex Hose- 1pc.
KVAC-1101
1-1/4" Round Brush- 1pc.
KVAC-1103
1-1/4" Gulper Tool- 1pc.
KVAC-1105
1-1/4" Crevice Tool- 1pc.
KVAC-1107
10" x 1-1/4" Floop Sweep- 1pc.
ON-BOARD ACCESSORY STORAGE
When accessories are not in use, they can be stored in the on-board storage as shown in
Fig.14.
MAINTAINING YOUR VACUUM AND ACCESSORIES
Warning! To reduce the risk of injury and electrical shock, unplug the power cord from
the power source. Airborn dust will be produced when cleaning, wear dust mask!
To maintain peak vacuum performance, the foam and re-usable filters must be cleaned often.
When not in use, wrap the power cord around the power cord posts as shown in Fig.15.
Filter maintenance- Clean the foam filter and re-usable filter by washing them inside out in a mild
soapy water and then rince with clean water. Allow these filters to dry completely before using.
General Maintenance and Inspection- The inside of the tank, hose and accessories should be
cleaned after every use, this cleaning should only be done outdoors with the power cord
disconnected from the power source. Check the condition of the power cord and make sure it is
not damaged. Also check the condition of the filters for tears and small holes. Do not use filters
with tears or small holes, replace with new filters.
TROUBLESHOOTING
Reduced efficiency/increased motor speed-
Inlet is block or tank is full- Unblock inlet or empty tank.
PARTS DIAGRAM & PARTS LISTS
Refer to the Parts section of the King Canada web site for the most updated parts diagram and
parts list.
OPERATION & MAINTENANCE
Usage
Wet•Dry Vacuuming Applications
Wet•Dry Vacuuming Applications
Replacement hose
Upholstery and car interiors
Upholstery and car interiors
General purpose
General purpose
Included/Optional
1pc. Included
1pc. Included
1pc. Included
1pc. Included
1pc. Included
1pc. Included
Optional
FIGURE 13
FIGURE 14
FIGURE 15

Advertisement

loading