Advertisement
6) Plug the power cord to a power source.
7) Start the vacuum by pushing the On/Off water proof switch to the On position as shown in
Fig.8. The On position is indicated by the international symbol "I" on the switch.
8) Once the vacuuming operation is finished, push the switch to the Off position indicated by the
international symbol "O" on the switch and unplug the power cord from the power source.
9) Remove the cover/motor assembly and lay it aside, being careful not to damage the filters
and dump the tank contents into a suitable waste disposal container. Airborn dust will be
produced when cleaning, wear dust mask!
Warning!
When vacuuming fine dust, it will be necessary to clean the foam filter and re-usable filter at
more frequent intervals.
WET VACUUMING OPERATIONAL STEPS
Before vacuuming wet materials, it is important that you have read and understood the
safety rules in this manual.
1) Unplug the power cord from the power source.
2) Remove the cover/motor assembly by undoing the 2 side mounted cover latches and install
a clean and dry foam filter. If wet vacuuming under normal conditions (small amounts of
liquid pick-up), the foam and re-usable filters can be installed, but when vacuuming large
amounts of liquid, only install the foam filter, see Fig.9. Make sure the inside of the tank is
clean.
3) Reposition and secure the cover/motor assembly to the tank using the 2 side mounted cover
latches.
4) Insert the hose into the inlet on the front of the vacuum and twist slightly to tighten.
5) Attach either the gulper tool or the crevice tool to the other end of the hose.
6) Plug the power cord to a power source.
7) Start the vacuum by pushing the On/Off waterproof switch to the On position as shown in
Fig.10. The On position is indicated by the international symbol "I" on the switch.
8) When vacuuming large amounts of liquid, do not completely immerse the nozzle accessory
in the liquid, leave a gap at the top of the nozzle accessory opening to allow air inflow.
9) Once the vacuuming operation is finished, push the switch to the Off position indicated by the
international symbol "O" on the switch and unplug the power cord from the power source.
Warning!
Never use the re-usable filter for vacuuming wet materials.
The foam filter should be cleaned after each wet vacuuming operation.
Should it become necessary to pick up the vacuum to move it, DO NOT pick up the vacuum by
the top handle unless the tank is empty. Do not pull the vacuum by the hose, this may tip the
vacuum over.
AUTOMATIC SUCTION SHUT-OFF AND EMPTYING LIQUID FROM TANK
This section relates to wet vacuuming operations. This vacuum is fitted with an automatic
suction shut-off float cup (A) Fig.12 which floats up when the liquid level increases in the tank,
it then stops the suction action when the tank has reached its maximum capacity of liquid. Make
sure the float cup is clean at all times.
The user will notice an increased motor speed, when this happens;
1) Turn off the vacuum immediately and unplug the power cord from the power source.
2) Remove the cover/motor assembly and lay it aside, being careful not to damage the filters
and dump the tank contents into a suitable waste disposal container.
3) The inside of the tank should be cleaned, also check the foam filter and clean it from the
inside out if necessary.
4) To continue vacuuming wet materials, reposition and secure the cover/motor assembly, plug
the power cord to a power source and proceed.
OPERATION
FIGURE 8
FIGURE 9
FIGURE 10
FIGURE 11
FIGURE 12
Advertisement
